What does the inner tie rod connect to?

What does the inner tie rod connect to?

The inner and outer tie rods connect to the steering arm in order to move the wheels of your vehicle. In the common rack-and-pinion steering system, the inner tie rods connect to the steering rack while the outer tie rods connect to the steering arms.

What is the inner tie rod socket connected to in a rack-and-pinion steering system?

Tie rods on a rack and pinion steering system The inner tie rod end connects to the rack and pinion steering gear and allows only up and down and some slight side to side movement. The outer tie rod, on the other hand, allows up and down AND left and right rotation so the wheel can make turns.

Where are the tie rod ends on a car?

Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.

How do you replace an inner tie rod?

Remove the boot from the inner tie rod end. Only do this if you are replacing both inner and outer tie rod ends. You will need to remove the pinch nut. Next, take a pair of pliers and remove the clamp from the boot on the inside end of the inner tie rod end.

Where is the cotter pin on a tie rod?

Remove the cotter pin. This pin will be located where the tie rod end meets the steering knuckle. Use a pair of needle nose pliers to straighten out the pin and then pull it out. Throw the cotter pin away. It should not be reused. Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through.

How do you remove a tie rod from a steering wheel?

Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator. Insert the tool between the ball joint of the outer tie rod end and the steering knuckle. Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end.

Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.

Remove the boot from the inner tie rod end. Only do this if you are replacing both inner and outer tie rod ends. You will need to remove the pinch nut. Next, take a pair of pliers and remove the clamp from the boot on the inside end of the inner tie rod end.

Remove the cotter pin. This pin will be located where the tie rod end meets the steering knuckle. Use a pair of needle nose pliers to straighten out the pin and then pull it out. Throw the cotter pin away. It should not be reused. Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through.

Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator. Insert the tool between the ball joint of the outer tie rod end and the steering knuckle. Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end.